Not registered yet? Take advantages of registration:
Products saving in a binding to the projects
Online consultation from experts

Privacy policy

Blauberg Valeo-BF 100

Mono-pipe ventilation exhaust centrifugal fans. Maximum air flow up to 100 m³/h.
  • Description
  • Characteristics
  • Capacity diagram
  • Downloads
  • Modifications
  • Dimensions
  • Designation key
Extract ventilation systems installed in high-rise buildings and premises.For buildings with mono-pipe ventilation system.For mounting in kitchens and bathrooms.Surface wall or ceiling mounting. Step speed control with an external speed controller, e.g. CDP-3/5 model which is available upon order.Wide range of intellectual controls programmable by set parameters (timer, adjustible timer, internal switch, humidity sensor).
The fan consists of the fireproof casing BF for flush mounting and exhaust ventilation unit Valeo with a flat front panel.
The casing is made of silicate plates based on calcium silicate and has high thermal insulating properties.Equipped with a fire-retarding damper to prevent fire and smoke expanding along air ducts. If temperature in the duct reaches 90°C the thermal fuse melts and closes the damper.When the fan is off the fire-retarding damper serves as a backdraft damper.The front panel is made of snow white UV-resistant plastic.Filter with filter class G4 for motor, impeller and ductwork system protection against soiling.The filter is easily accessible for service operations.Due to modern design and various colour modifications the front panel matches well with any interior.The casing is equipped with oblong slotted joints to facilitate mounting of the casing in true vertical position.If the casing is installed with some vertical deviations the special turnable grille conceals possible mounting inaccuracies.Power is supplied to the fan through a sealed electric lead-in on the casing and the ventilation unit is equipped with an airtight terminal block for connection to the wiring system.For room-to-room ventilation some ventilation unit modifications are equipped with extra spigots: Valeo-BFL – on the left; Valeo-BFR – on the right; Valeo-BFD – on the bottom.Ingress protection rating IP55.
Depending on wiring connection the fan is off or runs permanently at low speed. The fan is turned to higher speed with external switch 50 s after activation. After turning the switch off the fan continues operating within 6 min at higher speed and then reverts to default operation mode.
Depending on wiring connection the fan is off or runs permanently at low speed. If the fan is turned on with an external switch it switches to higher speed 0 to 150 s after switch activation. After turning the fan off it continues running at higher speed within 2 to 30 minutes and then reverts to previous mode. The fan run-out time and delay time for higher speed are regulated with the internal regulator.
Depending on wiring connection the fan is off or runs permanently at low speed. In interval mode regulated from 0,5 to 15 hours the fan switches periodically to higher speed for 10 minutes. The switch interval is adjusted with the internal regulator. If light in the room is turned with the external switch the fan switches to higher speed in 50 s. After light is off the fan reverts to interval mode operation.
Depending on wiring connection the fan is off or runs permanently at low speed. The fan switches to higher speed as relative humidity in the room increases from 60 % up to 90 % and switches off as humidity drops by 10 % below set level. If light in the room is turned on the fan switches to higher speed in 50 s. The run-out time is set by the internal regulator from 2 to 30 minutes.
Two- or three-speed motor with centrifugal impeller. Minimum energy demand.Galvanized steel impeller with forward curved blades.Automatic maintaining of constant air flow depending on variable air resistance of the duct.Balanced impeller ensures low-noise operation.Best aerodynamic characteristics due to special scroll casing design.Ball bearings provide long service life.The ventilation unit with motor is fixed inside the casing with special latches. Installed in wall or ceiling during general construction works by mounting brackets supplied as a standard.Connection to main ventilation shaft with flexible air ducts.Exhaust spigot diameter 80 mm.Power is supplied to the fan through a sealed electric lead-in on the casing.After installation works cover the unit with a protecting cover to prevent dirt ingress.After finishing works install the ventilation unit inside the casing and connect it to wiring system.
The standard snow white front panel can be replaced by the following models:

Grey metallic
natural brushed
Hi-tech Gold
natural gold-coloured
Hi-tech Chrome
natural mirror
The mechanical centralized mono-pipe exhaust ventilation system for kitchens and bathrooms based on Valeo-BF fans in fireproof casing with fire-retarding damper is specially designed for high-rise residential premises with high fire safety requirements. The inter-floor fire dampers are installed in the ventilation shaft to prevent fire and smoke extension in case of fire.Fresh air is supplied to bedrooms, children's room or living rooms through window or wall vents. Vent modifications with air volume regulation are available. Stale air is extracted by exhaust fans from the room through inside doors or door grilles in the kitchen, bathroom or WC.This ventilation system arrangement ensures non-stop controllable air circulation in the room, comfortable microclimate and high fire safety. 
1 – Exhaust fan Valeo-BFD with extra spigot for room-to-room ventilation.2 – Exhaust fan Valeo-BF.3 – BLAUBERG wall grille, DECOR series.4 – BLAUBERG wall vent, WMH series.5 – BLAUBERG window vent, FHM series.6 – BLAUBERG ventilation door grilles, DECOR series.7 – Central ventilation shaft.8 – Flexible thermal-resistant air ducts for connection of exhaust fans to the central ventilation shaft.9  Inter-floor fire damper. 
Parameter Valeo-BF 100
(1 speed)
Valeo-BF 100 T
(1 speed)
Valeo-BF 100 TR
(1 speed)
Valeo-BF 100 H
(1 speed)
Valeo-BF 100 I
(1 speed)
Measurement unit
Speed I I I I I -
Voltage 220-240 220-240 220-240 220-240 220-240 V
Cable cross section 3x1.5 3x1.5 3x1.5 3x1.5 3x1.5 mm
Frequency 50 50 50 50 50 Hz
Current 0.13 0.13 0.13 0.13 0.13 A
Power 29 29 29 29 29 W
Maximum air flow 28 28 28 28 28 l/s
Maximum air flow 100 100 100 100 100 m³/h
Sound pressure level at 3 m 38 38 38 38 38 dBА
Max. operating temperature +50 +50 +50 +50 +50 °С
Ingress protection rating IP55 IP55 IP55 IP55 IP55 -
EC motor no no no no no -
Casing material plastic plastic plastic plastic plastic -
Outdoor mounting no no no no no -
Sound-insulated casing no no no no no -
Air duct for round air ducts for round air ducts for round air ducts for round air ducts for round air ducts -
Design centrifugal centrifugal centrifugal centrifugal centrifugal -
Type Exhaust Exhaust Exhaust Exhaust Exhaust -
Mounting ceiling mounting, wall mounting ceiling mounting, wall mounting ceiling mounting, wall mounting ceiling mounting, wall mounting ceiling mounting, wall mounting -
Capacity diagram
Capacity diagram
  • Selection method:
  • Air capacity:
  • Pressure:
Operating point
  • Air capacity: --
  • Pressure: ---
Documents archieve
Documents archieve
Select a document type
  • Catalogues
  • Technical documentation
  • Certificates
Valeo-BF - data sheet (pdf 1.07Mb)
Valeo - user's manual (pdf 2.58Mb)
Valeo-BF - image (png 472.59Kb)
Sound insulation kit for the Valeo fans - installation instruction (pdf 427.93Kb)
Modification name Timer Humidity sensor Interval Timer No extra functions Adjustible timer
Valeo-BF 100 - - - -
Valeo-BF 100 H - - - -
Valeo-BF 100 I - - - -
Valeo-BF 100 T - - - -
Valeo-BF 100 TR - - - -

Designation key
Designation key
Series Front panel Air capacity according to speed


_: white plastic
Hi-Tech: natural aluminium
Hi-Tech Gold: aluminium in gold
Hi-Tech Chrome: aluminium in chrome
Platinum: grey aluminium lacquer
Vintage: painted vintage
Gold: electroplating on plastic in gold
Chrome: electroplating on plastic in chrome
35/60; 35/100; 35/60/100; 60/100; 75/100; 100 K: fire damper
T: timer
TR: regulated timer
I: interval switch
H: humidity sensor