Blauberg Vento Expert Duo A30-1 S10 Pro
- Description
- Modifications
- Downloads
- Designation key
- Technical data
- Accessories
Dear partners! Please note that as of the end of the third quarter of 2020, in order to increase the efficiency of the Vento Expert Duo, the company manufactures products with regenerators divided into two sections. |
|||||
Features | |||||
Arrangement of efficient energy-saving supply and exhaust single-room ventilation in flats, houses, cottages, social and commercial premises.Reducing heat losses caused by ventilation due to heat recovery.Humidity balance and regulated air exchange create individually controlled microclimate.Coordinated network based on several integrated single-room ventilation units with central control. |
|||||
Design | |||||
|
|||||
HEAT AND HUMIDITY REGENERATION | |||||
UNIT OPERATING LOGIC IN WINTER PERIOD | |||||
To increase the efficiency of the Vento Expert Duo, the regenerator is divided into two parts, which are isolated from one another, thus eliminating the transfer of heat and moisture between them.One of the fans operates in the supply mode: fresh cold intake air from outside flows through the first regenerator, and absorbs accumulated heat and humidity. |
At the same time, the other fan operates in the exhaust mode: warm stale air is extracted from the room to the outside, and while passing through the other regenerator, gradually heats it up and transfers some of the moisture.After 70 seconds operation the fans change the rotation direction and opposite processes start. |
||||
Control | |||||
Control of the unit operation mode is performed by means of the sensor control panel located on the unit casing or the remote controller. |
|||||
Vento Expert Duo either can operate as independent unit or can be wired with other units in a house and controlled with a master unit. In this case, only the master unit receives a signal from the remote control. |
Vento Expert Duo is equipped with a humidity sensor for indoor humidity control. If humidity increases above a set point, the unit boosts to the speed III. |
||||
Mounting | |||||
Vento Expert Duo must be installed in each room with high humidity like kitchen, bathroom to be ventilated while Vento Expert must be installed in each living room to be ventilated. |
The unit is designed for through-the-wall installation inside a prepared core hole in an outer wall of the building. |
||||
Model | Fans | Air duct | Rated air flow [m³/h] | Front panel | Ventilation hood type | Control |
Vento Expert | Duo: two fans with different rotation direction | A: round air duct | 30 | -1: flat front panel |
S10: white plastic hood AH-10 white 160 Duo |
Pro: control with touch buttons and a remote control |
|
Name | Description | |
FP VENTO Expert DUO A50 G3 |
G3 filter set. |
|
FP1 Vento Expert Duo A30 G3 |
G3 filter set. |
|
AH-10 *color* 160 Duo |
Plastic outer ventilation hood. Available in colours:
|
|
AH-10 chrome 160 DUO | Plastic outer ventilation hood with a plate with brushed stainless steel effect finish | |
AH-5 white 160 DUO | Stainless steel outer ventilation hood, painted white | |
AH-5 chrome 160 DUO | Outer ventilation hood made of brushed stainless steel | |
PP 160/0.5 | Outer ventilation hood for mounting from inside | |
R 160-500 | 500 mm air duct and plastic foam plug | |
R 160-700 | 700 mm air duct and plastic foam plug | |
LST Vento Expert DUO | Air stream separator | |
FB Vento Expert A50 | Remote control | |
CD-1 | CO₂ sensor with LED CO₂ indication and sensor button for operation mode selection | |
CD-2 | CO₂ sensor |