Blauberg VENTO inHome

inHome is a brand new dMVHR solutions for newbuild and retrofit single-room applications, offer efficient and cost-effective ventilation. New and stylish design of indoor unit will fit into any interior. Built-in light sensor controls the brightness of the control panel LEDs and activates night mode automatically.

Built-in humidity sensor allows unit to automatically select the mode, control the humidity level and prevents mold growth. Silent operation, making it perfect for living spaces. High efficiency (up to 95 %) heat recovery to reduce energy costs and helps you save on heating and air conditioning.

Low power consumption, making inHome suitable for continuous operation without significantly impacting energy bills. Remote management through a remote control. Easy to mount through external walls without the need for complex ducting.

Operation within a network guarantees balanced ventilation. Higher degree of supply air purification can be achieved with an ISO ePM1 60% (F7) filter (optional). Possibility to connect external sensors. Equipped with an automatic shutter to prevent undesired external entry when turned off (optional).

The ventilators can be connected into one network for centralized control. The signals from the control panel, remote control, as well as from the humidity sensor, are received only by the master (main) ventilator.

Control of the unit operation mode is also performed by means of the sensor control panel located on the unit casing or the remote control.

Vento inHome is equipped with a humidity sensor for indoor humidity control. If humidity increases above a set point, the unit boosts to the speed III.

UNIT OPERATING LOGIC IN WINTER PERIOD

Warm stale air is extracted from the premise, flows through the ceramic heat exchanger and transfers its heat and moisture to it. As the ceramic heat exchanger gets warmed up, the unit switches to the supply mode.

Clean cold intake air flows through the heat exchanger and absorbs accumulated heat and humidity. When the heat exchanger is cooled down, the unit switches to the extract air mode.

The unit is designed for through-the-wall installation inside a prepared hole in an outer wall of the building. The best ventilation solution is pairwise installation of reverse phase synchronized units. Some units ensure supply of fresh air to the room and the other units extract air from the premise. This way the most efficient balanced ventilation is arranged.

In case of brand new construction, units are mounted in two stages:

• Pre-installation of an air duct and an outer ventilation hood at the stage of indoor finishing and outer decorative wall finishing.
• Completion of the installation before commissioning of a house. It includes installation of the indoor unit with controller and shutters the cartridge, the heat exchanger, the fan and the filters.